We are more than a roofing contractor in Black Forest, we are a crew that knows the county rules that apply out here. Black Forest is unincorporated El Paso County, so permits run through the Pikes Peak Regional Building Department, and at roughly 7,369 feet the design requirement is 57 pounds per square foot of ground snow load and 40 pounds per square foot on a flat roof.
As your roofing company in Black Forest, Storm Guard covers houses, shops, and outbuildings on acreage. Residential roofing, commercial roofing, gutters, and emergency tarping.
Black Forest is roughly 100 square miles of large lot, tree covered property, closer to 11 or 12 acres per home than to a subdivision street. We handle roof repair and full replacement on homes where the nearest neighbor is a long way off.
Shops, barns, and detached garages are part of most Black Forest properties. We quote them alongside the house rather than making you book a second visit.
Ponderosa needles fill Black Forest gutters faster than leaves fill them anywhere else in the county, and a gutter packed with dry needles is also an ember trap. We install and repair gutter systems with that in mind.
When a hailstorm or a downed limb opens a roof, emergency roof tarping stops water getting into the structure while the claim is worked.
As your roofer in Black Forest, we begin with the two questions that matter most here: what the roof has to survive in a fire, and what it has to carry in a snow.
We inspect the whole roof, the valleys where needle litter collects, and the attic. On a wooded acreage property, the valleys usually tell the story first.
Our Black Forest roofing contractors provide an itemized written estimate, including the fire rated assembly and the valley flashing detail the county requires in wildfire zones.
We install to manufacturer specification with premium materials, built for the higher snow load above 7,000 feet and detailed for a property surrounded by pine.
After a thorough final roof inspection, we clear the site thoroughly, out past the drip line where debris ends up on a wooded lot.
Storm Guard uses only the highest quality materials sourced from top manufacturers. In Black Forest the roof covering conversation starts with fire rating, because El Paso County requires a Class A rated roof assembly in its designated wildfire zones.
As your go-to roofer in Black Forest, we build for fire, snow, and hail in that order. From roof replacement to gutters and emergency support, we do it all. Call us today for your consultation.
Black Forest presents a roofing environment that exists nowhere else in El Paso County. Dense ponderosa pine across roughly 100 square miles of large lot property means embers, needle litter, and limb strikes matter as much as hail and snow. The June 2013 Black Forest Fire burned 14,280 acres and destroyed 486 homes over ten days, and the county now applies wildfire resiliency requirements that call for a Class A rated roof assembly, firestopping at profile gaps in the roof deck, and valley flashing of 0.019 inch corrosion resistant metal over a 36 inch cap sheet in designated zones. Add a snow load requirement of 57 pounds per square foot of ground snow load and 40 pounds per square foot on a flat roof at 7,369 feet, and hail that reached three inches near Black Forest on 19 June 2018, and you have a roof that has to do three difficult jobs at once. That is the roof we build here.
In designated wildland urban interface areas of unincorporated El Paso County, which include Black Forest, the county wildfire resiliency requirements call for a roof covering or assembly classified as Class A when tested to ASTM E108 or UL 790. The same requirements address firestopping where a roof deck has profile gaps and specify valley flashing of 0.019 inch corrosion resistant metal over a 36 inch cap sheet.
The Pikes Peak Regional Building Department, because Black Forest is unincorporated El Paso County rather than an incorporated town. There is no separate Black Forest town hall to deal with, and residents voted against incorporating in 2006.
Black Forest sits at roughly 7,369 feet at the center of the community, above the 7,000 foot line in the regional design criteria, so the requirement is 57 pounds per square foot of ground snow load and 40 pounds per square foot on a flat roof. Given the size of the area, we confirm the elevation at your specific address before finalizing a design.
On a wooded acreage property the tells are:
Replace rather than repair when:
One to three days for the house, longer where outbuildings are included. Access on long private drives affects staging and dumpster placement, and we work that out before scheduling rather than on the morning.
Yes. We inspect, photograph, and attend the adjuster meeting so the scope covers the whole property, outbuildings included. Black Forest hail is serious: the National Weather Service logged a three inch hail report near Black Forest on 19 June 2018. We do not negotiate settlements, and no Colorado roofer may pay or waive your deductible.
Manufacturer coverage on materials and a Storm Guard workmanship warranty on installation. Where we install a Class A rated assembly, we document the specific rating, which is worth keeping for your insurer.
Fire rated assembly, snow load design, roof area, and access. Large lot properties often have bigger roof footprints and longer drives than a city house, and outbuildings add scope. We inspect and itemize each structure.
Attic heat in summer, marginally. What actually determines how a Black Forest roof performs is the fire rating of the assembly, the ventilation, and how well the valleys are kept clear of needle litter.
At 7,369 feet with real snow cover, a warm attic melts roof snow which then refreezes at the eave and forms an ice dam. Balanced intake and exhaust keeps the deck cold. It also helps the roof deck dry out after the wet spring snows this area gets.
Valleys. Ponderosa needles collect there, hold moisture against the covering, and shorten the life of that section well before the rest of the roof wears out. They are also the first place embers settle, which is why the county specifies valley flashing in detail.
Forty to seventy years with proper installation and maintenance. On a wooded lot metal has a second advantage beyond lifespan: it sheds needle litter rather than trapping it, and Class A rated metal assemblies are readily available for wildfire zone properties.
Carriers commonly move roofs past about 15 years onto an actual cash value basis, deducting depreciation. In a community that has taken both a catastrophic wildfire and repeated large hail, it is worth asking your carrier specifically how they treat a Class A rated replacement.
Unless otherwise noted, each use of "Storm Guard," “us,” “we,” or “our” throughout Stormguardrc.com collectively refers to both the Storm Guard brand and the Storm Guard Franchise System, which is made up almost exclusively of independently owned and operated franchise locations.
